DIP dust explosion-proof control box

DIP dust explosion-proof control boxScope of application
1. Hazardous areas with explosive gas mixtures: Zone 1, Zone 2.
2. Gas mixtures: IIA, IIB, IIC.
3. Flammable dust environment zones 20, 21, 22
4. Temperature group: T1-T6.
5. Explosion proof signs: Exde Ⅱ BT6, * Exde Ⅱ CT6.
█ Technical parameters
防爆标志： ExdeIIBT4/T5/T6、ExdeIICT4/T5/T6、DIP A20 TA,T4/T5/T6；
Rated voltage: AC220/380V, non-standard voltage: 12V/24V/36V/127V/660V;
Main switch current: 10A -800A; Switching current: 1A -630A;
Protection level: IP54/IP55/IP65;
Thread specifications: DN15-DN100/G1/2-G4 inches
Introduction line specifications: diameter 6mm-80mm; Lead out specifications: diameter 6mm-80mm;
Introduction and exit directions: upward and upward, downward and downward (unrestricted according to customer requirements)
Main Categories
Explosion proof distribution boxes are divided into: explosion-proof lighting box, explosion-proof power box, explosion-proof control box, explosion-proof control cabinet, explosion-proof distribution cabinet, explosion-proof operation box, explosion-proof box, explosion-proof starting box, explosion-proof motor starter, explosion-proof soft start, explosion-proof frequency conversion box, explosion-proof star delta starting box, explosion-proof autotransformer voltage reduction starting box, explosion-proof magnetic starting box, explosion-proof power socket box, mobile explosion-proof box, BMG explosion-proof distribution box, etc
Reactor matching control explosion-proof box

DIP dust explosion-proof control boxUsage
1. According to the actual lighting needs of the work site, determine the installation position and method of the lamps, and then prepare three core cables of corresponding length according to the distance from the lamps to the 220V power supply contact (if steel pipe wiring is used, introduce the three core cables into the steel pipe to the installation site of the lamps).
2. First, remove the fixing screws on the wiring chamber and pull out the wiring part of the junction box; Remove the sealing ring and connector (with fastening screws) from the packaging box, and sequentially insert the cable; Then connect one end of the three core cable to the marked "L", "N" and grounding points inside the box, press the cable tightly with a wire clamp, and fix it with a fastening screw. Then tighten the joint, tighten the sealing ring, and tighten the fastening screw from the side.
3. Screw the components of step 2 into the steel pipe, tighten the set screws from the side, then install the lamp body along the guide rail of the junction box, and tighten the screws on the panel.
4. Connect the other end of the three core cable to a 220V power supply according to the requirements of the explosion-proof distribution box.